1) If no display is showing , turn on power . Refer t o “T o T urn Unit On” in programming instructions for specifications.
2) If the clock is flashing , the unit has lost its power and current time setting. a. Reset current time. NOTE: all pre vious meal programming does not need t o be reset.3) If “MEALS” is flashing , this indicates the unit did not complet ely deliver the full amount of f ood programmed f or the meal.
a.T urn unit of f, empty the hopper and disassemble the hopper from the base. b. Check for f ood jamming in the throat of the base. c. Dislodge food jam. d. Reassemble unit. e. T urn unit on and reset current time. 4) If the “Low Battery” indicator light is lit: a. T urn unit of f. b. Replace the batteries. c. T urn the unit back on and set current time. NOTE: Meal programming r emains and does not need to be r eprogrammed. F . Replacement of Batteries/Po wer• When the “LOW B A TTERY” warning light is on OR befor e leaving f or an ext ended period of time, replace the batt eries.
• Refer t o “TO INST ALL BA TTERIES” for directions. • Once NEWbatteries are installed, turn unit ON. • Set clock to current time.IMPORT ANT : Meal Programming is stored and will NOT need to be reprogrammed after batteries are replaced.
T o Remove Bowl: 1) Place fingers under bowl and lif t Bowl up. 2) Pull Bowl out horizontally remo ving it from the Base. (Bowl is t op rack dishwasher saf e) NOTE: Lid and Hopper may be r emoved f or cleaning. Hand clean with sof t cloth and hand dr y .Base unit should not be submerged in water at an y time, this may damage electronic components. Do not place Base,
Hopper or Lid in an automatic dishwasher . Allow par ts to dry completely before adding ne w food. Default Settings:1 . While setting “Time” during the “Initial Setup” ; if the programming is not completed the Portion Control LeBistro ® waits
for y ou to finish.2. While setting the “Time” during the “Change Time” is not completed and no butt on depressed f or 1 0 seconds the
Portion Control LeBistro ® abandons the change and goes into “ Automatic Mode” retains the previous “Time” .
3. While setting the “Meals” during the “Initial SetUp”if no buttons ar e depressed f or 1 0 seconds the Por tion Control LeBistro ® abandons the change and goes int o “ Automatic
Mode” retaining the previous “Meals” settings.4. While setting the “Meals” during the “Change Meals” no buttons are depressed f or 10 seconds the P or tion Control
LeBistro ® abandons the change and goes int o “A utomatic Mode” retaining the pr evious “Meals” settings.
